The EL3044 analog input terminal processes signals in the range between 0 and 20 mA. The current is digitized to a resolution of 12 bits and is transmitted (electrically isolated) to the higher-level automation device.
The KL1304 digital input terminal acquires the binary 24 V DC control signals from the process level and transmits them, in an electrically isolated form, to the higher-level automation unit. The Bus Terminal has four channels, whose signal state is displayed by light emitting diodes.
Special features: compact design through the combination of inputs and outputs in one terminal no bouncing due to mechanical switches thanks to 3 ms input filter short-circuit proof outputs protected against reverse polarity with output current up to 0.5 A tool-free connection by direct plug-in technology for solid wire conductors increased packing density with 16 connection points in the housing of a 12 mm terminal block
The voltage for the sensors is supplied to the terminal via the power contacts. The power contacts can optionally be supplied with operating voltage in the standard way or via a power feed terminal (KL9xxx) with electrical isolation.
The voltage for the sensors is supplied to the terminal via the power contacts. The power contacts can optionally be supplied with operating voltage in the standard way or via a power feed terminal (KL9xxx) with electrical isolation.
The job of the KL3044 analog input terminal is to transmit analog measurement signals with electrical isolation to the automation device. The input electronics is independent of the supply voltage of the power contacts.
Bently Nevada 330400-02-CN dynamic signal sensor vibration transmitter Bentley unit vibration monitoring can be connected to PLC or DCS systems, including 4-20mA current output and two-stage relay alarm output
330400-02-00 The electronic overspeed detection system of Bently Nevada's 3500 series mechanical detection system is a highly reliable and responsive redundant tachometer system specifically designed for mechanical overspeed protection. The system complies with the American Petroleum Institute standards 670 and 612 for overspeed protection
330171-00-12-10-01-05 Can be widely used in large rotating machines such as fans, compressors, pumps, etc. Measure the vibration of bearing seats, casings, etc.
Bently Nevada 330400-02-05 Can be widely used in large rotating machines such as fans, compressors, pumps, etc. Measure the vibration of bearing seats, casings, etc.
English
español
العربية
Indonesia
